KTM 125 Duke Owner's Manual page 89

WHEELS, TIRES
–
Check the wheel bearing for damage and wear.
» If the wheel bearing is damaged or worn:
–
Change the wheel bearing.
–
Clean and grease the shaft seal rings
Long-life grease (
–
Clean the thread of the wheel spindle and screw
–
Lift the front wheel into the fork, position it, and insert the wheel spindle. Mount and
tighten screw
Guideline
Screw, front wheel spindle
–
Operate the hand brake lever repeatedly until the brake linings are in contact with the
brake disc and there is a pressure point.
–
Take the motorcycle off of the front wheel stand. (
–
Pull the front wheel brake and push down hard on the fork several times to align the
fork legs.
–
Tighten screws
B00744-10
Guideline
Screw, fork stub
–
Take the motorcycle off of the rear wheel stand. (
x
and mating surfaces

p. 149)
.

.

of the spacers.

.

M8 25 Nm
(18.4 lbf ft)
p. 64)
M8 15 Nm
(11.1 lbf ft)
p. 66)
87