KTM 125 Duke Owner's Manual page 91

WHEELS, TIRES
Warning
Danger of accidents No braking effect when operating the rear brake.
–
After installing the rear wheel, always operate the foot brake until the pressure point is reached.
–
Check the rear hub rubber dampers.
–
Check the wheel bearing for damage and wear.
» If the wheel bearing is damaged or worn:
–
Change the wheel bearing.
–
Clean and grease the shaft seal rings
Long-life grease (
–
Clean the thread of the axle and nut
–
Clean the fixing locations on the brake caliper support and swingarm.
–
Install the rubber damper and rear sprocket carrier on the rear wheel.
B00748-10
–
Stand the rear wheel in the swingarm and mount the brake caliper on the brake disc.
–
Position the rear wheel on the contact surfaces in the swingarm.
–
Push the rear wheel as far forward as possible and place the chain on the rear sprocket.
x ( p. 90)
x
and mating surfaces

p. 149)
.

89
of the spacers.
