3
WORK
3.4
Refitting the headlight mask with the headlight
3.5
Checking the headlight setting
3.6
Adjusting the headlight range
Main work
–
Connect the electric plug connector
B01561-11
–
Position the headlight mask and fix it with the rubber band
Info
Ensure that the retaining lugs engage in the fender.
–
Position the brake line and wiring harness. Put the clamp on, mount and tighten
screw
.
3
B01560-11
Finishing work
–
Check the headlight setting. (
–
Position the vehicle upright on a horizontal surface in front of a light wall and make
a mark at the height of the center of the low beam headlight.
–
Make another mark a distance
Guideline
Distance
–
Position the vehicle vertically a distance
Guideline
Distance
400726-10
–
The rider now sits down on the motorcycle.
–
Switch on the low beam.
–
Check the headlight setting.
The boundary between light and dark must be exactly on the lower mark for a
motorcycle with driver.
»
If the light-dark border does not meet specifications:
–
Adjust the headlight range. (
Preparatory work
–
Check the headlight setting. (
Main work
–
Loosen screw
–
Adjust the headlight range of the headlight by moving it up or down.
Guideline
The boundary between light and dark must be exactly on the lower mark for a
motorcycle with driver (instructions on how to apply the mark: Checking the
headlight setting).
Info
B01620-10
A change in weight on the vehicle may require a correction of the headlight
range.
1
p. 9)
under the first mark.
B
B
A
p. 9)
.
1
.
.
2
5 cm (2 in)
away from the wall.
A
5 m (16 ft)
p. 9)
9