15 ELECTRICAL SYSTEM
15.7
Note
Impairments to reflectors and lamps Grease on the reflector reduces the emitted light.
Grease on the bulb will evaporate due to the heat and be deposited on the reflector.
Grease residue on the bulb reduces heat dissipation and increases the heat of the bulb, thus reducing its service
life.
–
Clean and degrease the bulbs before mounting.
–
Do not touch the bulbs with your bare hands.
15.8
120
Changing the headlight bulb
I00431-10
I00432-10
Checking the headlight setting
400726-10
Preparatory work
–
Remove the headlight mask with the headlight. (
Main work
–
1
Turn LED unit
counterclockwise all the way and take it out
of the reflector.
–
Insert the LED unit into the reflector and turn it clockwise all
the way.
Headlight (LED)
Info
Ensure that O-ring
Finishing work
–
Install the headlight mask with the headlight. (
–
Check the headlight setting. (
–
Park the vehicle on a horizontal surface in front of a light-
colored wall and make a mark at the height of the center of
the low beam headlight.
–
Make another mark at a distance
Guideline
B
Distance
–
Position the vehicle vertically at a distance
wall.
Guideline
A
Distance
–
The rider now sits down on the motorcycle.
–
Switch on the low beam.
p. 119)
2
is seated properly.
p. 119)
p. 120)
B
under the first marking.
5 cm (2 in)
A
away from the
5 m (16 ft)