Table of Contents
Advertisement
15.7
Changing the headlight bulb
15.8
Checking the headlight setting
Preparatory work
–
Remove the headlight mask with the headlight. (
Main work
–
Turn LED unit
of the reflector.
Guideline
Only touch the LED unit on the cooling element.
I00431-10
–
Insert the LED unit into the reflector and turn it clockwise all
the way.
Headlight (LED)
Info
Ensure that O-ring
I00432-10
Finishing work
–
Install the headlight mask with the headlight. (
–
Check the headlight setting. (
–
Position the vehicle upright on a horizontal surface in front of
a light wall and make a marking at the height of the center of
the low beam headlight.
–
Make another mark at a distance
Guideline
B
Distance
–
Position the vehicle vertically at a distance
wall.
400726-10
Guideline
A
Distance
–
The rider now sits down on the motorcycle.
–
Switch on the low beam.
–
Check the headlight setting.
The boundary between light and dark must be exactly on the
lower mark for a motorcycle with rider.
»
If the boundary between light and dark does not meet
specifications:
–
Adjust the headlight range. (
ELECTRICAL SYSTEM 15
1
counterclockwise all the way and take it out
2
is seated properly.
p. 117)
B
under the first marking.
5 cm (2 in)
A
5 m (16 ft)
p. 118)
p. 115)
p. 116)
away from the
117
Advertisement
Table of Contents
