Leveling The Build Plate - Flashforge DREAMER Quick Start Manual

Leveling the Build Plate

1
The blue build tape has been pasted on the build plate
1
before leaving factory. (If changing tape is needed,
please heat the build plate up to 110
Turn the nut clockwise
Turn the nut anticlockwise
Raise the build plate to reduce Lower the build plate to increase
the distance between the plate the distance between the plate
and nozzle. and nozzle.
3 Once the extruder and build plate stop moving, slide the leveling
tool (a blue sheet) continuously back and forth between the nozzle
and the build plate. And simultaneously adjust the screw just
enough so that the paper causes a slight friction.(Scan the QR
code on the leveling tool card to watch the instructional video.)
for easier operation.)
2
HOME
Filament Level Home
Setting Monitor About
From the main menu, tap [Tools] and [Level]. The extruder and
2
build plate will begin to move to the starting position.
Please adjust the front thumb screw under
Platform when stop.
Next
4 Tap [Next] to start the second position leveling and
repeat the same leveling technique, and then go on
with the other positions to finish this leveling.
Jog Mode