Loading Filament - Flashforge DREAMER Quick Start Manual

6

Loading Filament

1
HOME
Filament Level Home
Setting Monitor About
1. Remove the lid of the Dreamer; tap the right icon labeled [Tools],
then tap [Filament].
2. Select [Load Left] or [Load Right] as you want.
3. Wait for the extruder to heat up to the operating temperature with an alert.
4. Secure the filament with a flat cross-section and load it by inserting the
filament into the extruder at an upright angle, meanwhile press down the
spring presser.
5. Filament will start to extrude out of the nozzle. Continue loading to
ensure that the filament is extruding in a straight line.
Changing Filament
1. Cut off the filament.
2. Tap [Tools]--[Filament]--[Load Left / Right] options in sequence to
load the snipped filament into the extruder.
3. When the snipped filament is extruded out of the nozzle, repeat the
last three steps of loading filament to complete operation of changing filament.
Do not pull out the filament with force as it will damage the gears. If the melted filament has cooled down in the extruder, please repeat
Notes
the steps of changing filament to load new filament.
2
Load Left
Unload Left
Jog Mode
Load Right
Unload Right
3
L Extruder
Loading Filament
Press down
Heating...
23%
55℃ / 230℃
Cancle
Press down