Flexfx; Headphone Cue; Channel Faders & Crossfader; Channel Meters - Rane SIXTY-ONE Operator's Manual

FLEXFX

The FLExFx button assigns a PGM channel to
the FlexFx bus where external analog (with the
ANALOG INSERT button) or software effects via USB
(with the INSERT button) may be inserted,
such as Scratch Live DJ-FX.
FX" ON PAGE 39.
The FlexFx loop allows any combination of
PGM 1, PGM 2, MIC or AUx to be assigned to
external analog effects or software effects via
USB.
The DRy / WET pan control lets you set the
amount of FlexFX in the Main Mix. DRy equals no
effect, WET gives maximum effect.
HEADPHONE CUES
Headphone CUE assigns a signal to the
headphone monitor. Headphone Cue controls
operate as solo or radio-button controls. This
means engaging a headphone Cue turns all
the other headphone Cue controls off. You can
select more than one at a time by simultaneously
pressing more than one CUE button.
CHANNEL FADERS & CROSSFADER
These faders use magnetic
mechanisms with no noise and no bleed. Each
fader has REVERSE and CONTOUR controls.

CHANNEL METERS

Each PGM channel has a mono meter to assist
in setting levels. These meters are quasi-peak
with peak hold. The goal is to stay out of the red.
The best method is to bring up a PGM fader
all the way, then adjust the channel LEVEL control
so that red flashes are rare to none.
RANE SIXTY-ONE FOR SERATO SCRATCH LIVE
MUTE SWITCHES
These joysticks provide quick program mute,
much like transform switches on the other
mixers. The signal is ON in the straight-up
position, a push in any direction kills the signal.
SEE "ENABLE DJ-

AUX

This digital input is on USB
playback stereo pair 5-6 and is
normally used for the Scratch
Live SP-6 sample player. This
AUx input has it's own LEVEL,
FLExFx assign and CUE.
To assign the SP-6 Sample
Player to
SP-6 tab on the main Scratch Live screen and
select "A" as the SP-6 output.
SAMPLE PLAyER" ON PAGE 39.

MiC iNPUT

This Mic input on a XLR/
TRS combo jack has LEVEL,
HIGH and LOW tone controls,
FLExFx assign and a meter.
Select MIC or LINE level
non-contact using the rear panel switch.
LINE is usually correct for
wireless mic receivers. The
Mic is OFF when the LEVEL
control is at "0".
• OPERATOR'S MANUAL
AUx, click the
SEE "ENABLE SP-6
2.4

SESSION IN AND OUT

The SESSION IN has it's own LEVEL
control and may be used as a
general purpose analog RCA
jack AUX input.
The SESSION OUT has it's own
LEVEL control and may be used
as a general purpose RCA jack
Main Mix output.
SESSION IN and SESSION OUT are
typically used to chain mixers
together.

MAiN OUT

The Main outputs have a Level
control and a quasi-peak stereo
meter with peak hold.

HEADPHONES

The Headphone monitor
provides stereo or mono split-
cue operation.
• In Stereo operation, the PAN
control pans between stereo
Cue and stereo Main Mix.
• In SPLIT CUE operation, the PAN
control pans between Mono
Cue in the left ear and mono
Main Mix in the right ear.
• Individual CUE buttons are provided for PGM 1,
PGM 2, AUx and FLExFx.
• The Headphone Level control sets the level
coming from both of the front panel 3.5 mm
and ¼˝ output jacks.
9