Setup; Operation Mode; Shdsl.bis - Planet GRT-101 User Manual

10.16 Setup

All of the setup parameters are located in the subdirectories of setup. Move the cursor " >> " to
setup and press enter.
>> mode

Shdsl.bis

wan
bridge
vlan
stp
route
lan
ip_share
firewall
ip_ qos
dhcp
dns_proxy
hostname
default

10.16.1 Operation Mode

The product can act as routing mode or bridging mode. The default setting is routing mode.
You can change the system operation mode by using mode command. Move the cursor " >>
" to mode and press enter.
----------------------------------------------------------------------
Command: setup mode <Route|Bridge>
Message: Please input the following information.
System operation mode (TAB select) <Route>: Route
----------------------------------------------------------------------
Operation Mode:
Operation Mode
10.16.2 SHDSL.bis
You can set up the SHDSL parameters by the command shdsl. Move the cursor " >> " to shdsl
and press enter.
`>> mode
link
n*64
type
margin
tcpam
probe
tclayer
clear
Switch system operation mode
Configure SHDSL parameters
Configure WAN interface profile
Configure transparent bridging
Configure virtual LAN parameters
Configure bridge STP parameters
Configure routing paramters
Configure LAN interface profile
Configure NAT/PAT parameters
Configure Firewall parameters
Configure IP QoS paramters
Configure DHCP parameters
Configure DNS proxy parameters
Configure local host name
Restore factory default setting
□Route □Bridge
Configure SHDSL.bis mode
Configure shdsl.bis link
Configure SHDSL.bis data rate
Configure SHDSL.bis annex type
Configure SHDSL.bis SNR margin
Configure shdsl.bis TCPAM type
Configure shdsl.bis line probe
Configure shdsl.bis TC Layer
Clear current CRC error count
GRT-101/401/402 User's Manual
123 - -
G.SHDSL Bridge/Router