Chapter 10 . Configuration via Serial
Console or Telnet with Menu Driven
10.1 Serial Console
Check the connectivity of the RS-232 cable from your computer to the serial port of ROUTER.
Start your terminal access program with VT100 terminal emulation. Configure the serial link
with the following values:
Press the SPACE key until the login screen appears. When you see the login screen, you can
logon to Router.
Only SPACE key invoke the login prompt. Pressing
other keys does not work.
User: admin
Password: *****
The factory default user and passwords are both "admin".
10.2 Telnet
Make sure the correct Ethernet cable connects the LAN port of your computer to this Router.
The LAN LNK LED indicator on the front panel will light up if a correct cable is used. To start
your Telnet client with VT100 terminal emulation and connect to the management IP of Router,
wait for the login prompt appears. Input User and Password after login screen pops up.
User: admin
Password: *****
Parameter
Baud rate
Data Bits
Parity Check
Stop Bits
Flow-control
101
- -
G.SHDSL Bridge/Router
GRT-101/401/402 User's Manual
Interface
Value
9600
8
No
1
No