Removing Staple Jams - Sharp MX-M260 Operation Manual

TROUBLESHOOTING AND MAINTENANCE

Removing staple jams

Follow the steps below to remove a staple jam.
1
Open the cover.
2
While pressing the lever over to the
left, slide the finisher to the left until it
stops.
3
Lower the staple case release lever
and remove the staple case.
4
Raise the lever at the front end of the
staple case and remove the jammed
staple.
Take care that a bent staple does not hurt
Caution
you.
136
Downloaded From ManualsPrinter.com Manuals
Gently slide the finisher
until it stops.
Pull the staple case out
to the right.
Remove the leading
staple if it is bent. If bent
staples remain, a staple
jam will occur again.
5
Lower the lever at the front end of the
staple case.
6
Replace the staple case.
7
Slide the finisher back to the right.
8
Close the cover.
Push the staple case in
until it clicks into place.
Gently slide the finisher
back to the right until it
locks into its original
position.