Sharp MX-M260 Operation Manual page 39

1
Place the originals in the RSPF or on
the document glass. (p.23, p.24)
Example: 5 sets of copies or 5 copies per page of 3
originals
Originals
2
Touch the [OUTPUT] key.
2-SIDED COPY
OUTPUT
3
Touch the [SORT] or [GROUP] key.
CENTRE
TRAY
4
Touch the output tray that you wish to
use.
UPPER
TRAY
CENTRE
TRAY
To enable the offset function (p.36), touch the
Note
[OFFSET] checkbox so that a checkmark
appears. To disable the offset function, touch
the [OFFSET] checkbox again to clear the
checkmark.
Downloaded From ManualsPrinter.com Manuals
If originals are placed in
the RSPF, the sort
function is automatically
selected. (To disable this
function, see the "6.
SYSTEM SETTINGS
(ADMINISTRATOR)".)
The output tray can only
be selected when a job
separator or finisher is
installed.
CONVENIENT COPY FUNCTIONS
5
Touch the [OK] key.
OK
OFFSET
6
Select the number of copies and any
other desired copy settings, and then
press the [START] key (
LOGOUT
UT
7
[When using the RSPF:]
Copying will start after all the originals are
scanned.
[When using the document glass:]
Replace the original with the next original and
press the [START] key ( ). Repeat this step until
all originals have been scanned, and then touch
the [READ-END] key.
PLACE NEXT ORIGINAL. PRESS [START].
WHEN FINISHED, PRESS [READ-END].
The copies are grouped as follows:
Sort
Copy
5 sets of copies
If the memory becomes full while scanning the
originals, "MEMORY IS FULL. PRESS [START] TO
BEGIN COPYING OR [CA] TO CANCEL." will appear.
To copy only the originals that have been scanned,
press the [START] key ( ) . To cancel the job, press
the [CLEAR ALL] key ( ).
The number of originals that can be scanned into
Note
memory can be increased by increasing the
memory allocation in the administrator settings, or
by installing more memory. (See "6. SYSTEM
SETTINGS (ADMINISTRATOR)".)
).
READ-END
Group
Copy
5 copies per page
37
3