Staple Cartridge Replacement - Sharp MX-M260 Operation Manual

STAPLE CARTRIDGE REPLACEMENT

(when the finisher (MX-FN13) is installed)
When the staple cartridge runs out of staples, a message will appear in the operation panel. Follow the procedure
below to replace the staple cartridge.
Replacing the staple cartridge
1
Open the cover.
2
While pressing the lever over to the
left, slide the finisher to the left until it
stops.
3
Lower the staple case release lever
and remove the staple case.
4
Remove the empty staple cartridge
from the staple case.
Note
Make a test print or copy in staple sort mode to verify that stapling takes place correctly.
Downloaded From ManualsPrinter.com Manuals
Gently slide the finisher
until it stops.
Pull the staple case out
to the right.
5
Insert a new staple cartridge into the
staple case as shown.
6
Replace the staple case.
7
Slide the finisher back to the right.
8
Close the cover.
Push the staple cartridge
in until it clicks into place.
Push the staple case in
until it clicks into place.
Gently slide the finisher
back to the right until it
locks into its original
position.
135
5