Sharp MX-M260 Operation Manual page 41

1
Place the original(s). (p.23, p.24)
2
Touch the [OUTPUT] key.
2-SIDED COPY
OUTPUT
3
Touch the [STAPLE SORT] key.
4
Touch the [OK] key.
5
Select the number of copies and other
copy settings, and then press the
[START] key (
Downloaded From ManualsPrinter.com Manuals
When the [STAPLE
SORT] key is selected,
the offset tray is
automatically selected as
the output tray. The top
tray and centre tray
cannot be used.
).
CONVENIENT COPY FUNCTIONS
6
[When using the RSPF:]
Copying will start after all originals have been
scanned.
[When using the document glass:]
Replace the original with the next original and
press the [START] key ( ). Repeat this step until
all originals have been scanned, and then touch
the [READ-END] key.
PLACE NEXT ORIGINAL. PRESS [START].
WHEN FINISHED, PRESS [READ-END].
If the memory becomes full while scanning the
originals, "MEMORY IS FULL. PRESS [START] TO
BEGIN COPYING OR [CA] TO CANCEL." will appear.
To copy only the originals that have been scanned,
press the [START] key ( ). To cancel the job, press
the [CLEAR ALL] key ( ).
The number of originals that can be scanned
Note
into memory can be increased by increasing
the memory allocation in the administrator
settings, or by installing more memory. (See
"6. SYSTEM SETTINGS (ADMINISTRATOR).)
READ-END
3
39