Enable Ethertalk; Enable Netbeui - Sharp MX-M260 Operation Manual

SYSTEM SETTINGS (ADMINISTRATOR)

ENABLE EtherTalk

This program must be enabled to use the machine on
a network that uses EtherTalk protocol.
This program is initially enabled (factory default setting).

ENABLE NetBEUI

This program must be enabled to use the machine on
a network that uses NetBEUI protocol.
This program is initially enabled (factory default
setting).
RESET THE NIC
This program is used to restore all network settings to
the factory default settings.
Some programs in the following are marked by "*1". This indicates that a message will appear at the end of the
Note
setting procedure asking you to confirm execution of the new setting. If needed, you can cancel the new setting
by touching the [NO] key.
114
Downloaded From ManualsPrinter.com Manuals
*1
INITIALISE AND/OR STORE SETTINGS
(When the PRINTER EXPANSION KIT is installed)
These programs are used to return the configuration
settings (See the online manual for network printer)
and the "PRINT SETTINGS" (p.111) to the factory
default settings. The programs are also used to store
the current settings and to restore stored settings.
"INITIALISE AND/OR STORE SETTINGS" consists of
the following programs:
● RESTORE FACTORY DEFAULTS
● STORE CURRENT CONFIGURATION
● RESTORE CONFIGURATION
RESTORE FACTORY DEFAULTS
This program is used to return the configuration
settings (see the online manual for network printer)
and the "PRINT SETTINGS" (p.111) to the factory
default settings. If you need a record of the current
settings before restoring the factory defaults, use
"Data list print" in the system settings (general) to print
a list of the current settings. (See "5. SYSTEM
SETTINGS (GENERAL)".)
STORE CURRENT CONFIGURATION
This program is used to store the current configuration
settings (see online manual for network printer) and
"PRINT SETTINGS" (p.111). The stored settings will
not be erased even if the power is turned off. To
restore the stored settings, use the "RESTORE
CONFIGURATION" program.
RESTORE CONFIGURATION
This program is used to restore settings that were
stored using the "STORE CURRENT
CONFIGURATION" program.
The current settings will change to the restored
settings.
If any of the "NETWORK SETTINGS"
Note
(p.113) were changed before execution of
this program, you must turn off the
machine's power switch, wait briefly, and
then turn the switch back on in order to
make the settings take effect.
*1
*1
*1