Making Conference Calls - Panasonic KX-NT700 Operating Instructions Manual

Making and Answering Calls
•
Press the dial key corresponding to the desired
character, then press [ ] or [ ] to scroll if
necessary.
•
To exit the phonebook, press [MENU].
3.
When the desired entry is displayed, press [
.
Note
•
The line that was selected when the entry was
stored in the phonebook ("IP" or "TEL") is
shown in the lower-right corner of the display.
This line will be used when the entry is called.
Example:
•
If the "Line Selection" setting is not set to
"IP + TEL" (see page 33), TEL line numbers
cannot be called.
36 Operating Instructions

Making Conference Calls

While on a call, you can make another call and establish
a conference call (i.e., a 3-party call) including yourself
and 2 other parties. You can establish a conference call
] or
using the following types of calls.
–
2 IP calls
–
1 IP call and 1 TEL call
–
1 IP call and 1 PS call
–
1 IP call and 1 PC call
To establish a conference call when you receive a call,
see page 38.
Note
•
The TEL line will
be used when
you call this
number.
Conference calls using the IP and TEL lines
1.
Press
2.
Confirm that the desired line ("IP" or "TEL") is
selected.
•
The IP line is selected.
•
3.
Call the party you want to add to the conversation.
•
•
4.
After the called party answers, press
begin the conference call.
•
When "Panasonic PBX Compatibility" in
"Protocol Settings" is set to "On", you
cannot make a conference call using 2 IP lines
in "IP-PBX" mode (see page 58).
to put the current call on hold.
CONF
If the current call is an IP call, you can change
the selected line by pressing the left function
button ([F1]).
[F1]
If you cannot select the desired line, press
, then change the "Line Selection"
BACK
setting (see page 33). After you have changed
the setting, repeat this procedure from step 1.
You can end the second call and return to the
original call by pressing
To call a party stored in the phonebook, see
page 35.
Before beginning the conference call, press
to end the second call and return to the
END
original call.
The TEL line is
selected.
[F1]
.
BACK
to
CONF
Document Version 2011/06