Preparation
Setting the Date & Time
Set the unit's date and time setting before using the unit.
The date and time are shown on the display in standby
mode, and are displayed when playing conversations
that were recorded to an SD memory card.
1.
Press [MENU].
2.
Select "Basic Settings", then press
3.
Select "Date & Time", then press
4.
Using the keypad, enter 2 digits each for the year,
month, day of the month, hour (24-hour format), and
minute.
Example: To enter "Jan. 23, 2011, 7:45 PM", press
[1101231945].
•
If you make a mistake, press
the cursor as needed, then enter the correct
number.
5.
Press
.
SAVE
6.
Press [MENU].
Note
•
You can select 12-hour or 24-hour time display
(see page 52).
•
The date format varies by the selection made
for the "Language" setting. See page 51 for
details.
26
Operating Instructions
TEL Line Settings
Selecting the Available Lines
To use the TEL line, the "Line Selection" setting
must be set to "IP + TEL". (This is the default setting.)
1.
Press [MENU].
2.
Press
.
SELECT
3.
Select "IP + TEL".
.
SELECT
•
4.
Press
5.
Press [MENU].
to move
Setting the Dial Mode
Set the dial mode to "Pulse" if the TEL line does not
support tone dialing.
1.
Press [MENU].
2.
Select "TEL Settings", then press
3.
Select "Dial Mode", then press
4.
Select "Pulse" or "Tone".
5.
Press
6.
Press [MENU].
.
LINE
When "Line Selection" is set to "IP +
PC" or "IP + PS", TEL calls cannot be made or
received.
.
SAVE
.
SAVE
Document Version
.
SELECT
.
SELECT
2011/06