Installing The System Board - Toshiba Satellite R10 Maintenance Manual

4 Replacement Procedures

Installing the system board

The following describes the procedure for installing the system board. (See Figure 4-30.)
1. Install the system board to the cover assembly and secure it with the following
screw.
M2.0x6.0B
NOTE: When installing the system board, be careful not to catch the mic (L&R) cable,
rotation sensor cable and digitizer cable between the system board and cover
assembly. Also confirm that these cables are not hidden under the system
board.
2. Connect the digitizer cable to the connector CN9540 on the system board.
3. Connect the rotation sensor cable to the connector CN3280 on the system board.
4. Connect the mic (R) cable to the connector CN6061 on the system board.
Satellite R10 Maintenance Manual (960-509)
FLAT BIND screw
4.19 System board
x1
4-45