Toshiba Satellite R10 Maintenance Manual page 266

4.16 LCD harness holder
Installing the LCD harness holder
The following describes the procedure for installing the LCD harness holder (See Figure
4-26).
1. Install the LCD harness holder to the cover assembly by fitting the boss and
secure it with the following screws.
M2.0x6.0B
2. Connecting the QI board cable to the connector CN9521 on the CN board and to
the connector CN9530 on the QI board, arrange the QI board cable along the
guide of LCD harness holder.
3. Connecting the CN board harness to the connector CN9502 on the system board
and to the connector CN9520 on the CN board, arrange the CN board harness
along the guide of LCD harness holder.
NOTE: When connecting the CN board harness, make sure that the connector with
core side is connected to the CN board.
4. Connect the LCD harness to the connector CN5501 on the system board and
arrange the LCD harness along the guide of LCD harness holder.
5. Connecting the USB harness to the connector CN4612 on the system board and
to the connector CN4621 on the CN board, arrange the USB harness along the
guide of LCD harness holder.
4-40
FLAT BIND screw
4 Replacement Procedures
x2
Satellite R10 Maintenance Manual (960-509)