Toshiba Satellite R10 Maintenance Manual page 205

3 Tests and Diagnostics
(2) Audio CD
Insert an audio CD and the following menu appears in the display.
CD/DVD TEST
SUB-TEST : XX
PASS COUNT : XXXXX
WRITE DATA : XX
ADDRESS : XXXXXX
CD Sound track number (01-98 : Track) ?
Select the track number you want to test and press Enter twice.
The following message appears in the display and selected track is played.
Play start CD sound !
Press any key <play stop>
After pressing any key, the music stops and the display returns to the selection menu of the
track number.
NOTE: When the CD-ROM test is executed, "ALL DEVICE" must be selected in the
[Device Config.] of the BIOS SETUP. If the "ALL DEVICE" is not selected,
music can not be played.
3.31.4 CD Sound (Legacy) test
To execute the CD Sound (Legacy) test, select 4 and press Enter.
CAUTION: Sound (Legacy) test is not supported in this model.
Satellite R10 Maintenance Manual (960-509)
IN PROGRESS XXXXXXXX
ERROR COUNT: XXXXX
READ DATA
STATUS
3.31 Sound Test program
xxxxxxx DIAGNOSTIC TEST VX.XX
[Ctrl]+[Break] ; test end
[Ctrl]+[C]
: XX
: XXX
Drive # = 0, ATAPI status =00
Command = XX
[[Block address = XXXXXXXX]]
[[Block length
Final : Block address = XXXXXXXXX
; key stop
= XXXXXXXX]]
3-91