Table of Contents
Advertisement
Saia-Burgess Controls AG
Please ensure:
● that all wires are screwed down tight
● that the connecting plug is properly engaged
● that the ventilation slots are placed above and below (positioning)
● that the device is mounted horizontally.
To prevent a premature oxidation and yellowness of the plastic enclosure of
the room control unit, the following installation conditions has to be prevent
(non-exhaustive list):
■ Exposure to intensive sunlight or intensive artificial lights (intensive neon tubes
light in particular)
■ Exposure to chemical products such as: intensive & frequent use of cleaning
chemical products (Bleach, ...), disinfectant sprays etc.
■ Exposure to high humidity rates; salted humidity could increase further the
oxidation
■ Exposure to high ratio of oxygen
■ Exposure to high heat
1
Assembling the
housing base
Manual for PCD7.L6xx room operator units │ D ocument 26-859 ENG07 │ 2 015-06-04
Mounting
2
Wiring to the device
Assembly instructions
Removal
Saia® DDC
3
4
Unlocking
Remove the case
1
1-2
Advertisement
Table of Contents
