Table of Contents
Advertisement
Saia-Burgess Controls AG
1
Assembly instructions
■ The room control units must only be installed and connected by an expert in
accordance with the wiring diagram. Existing safety standards must also be
observed.
■ The room control units can only be used to regulate the temperature in dry,
closed rooms. The maximum permissible relative humidity is 90%, non-
condensing.
■ Precise temperature measurement is subject to certain requirements as to the
positioning of the temperature sensors. This applies both to the room control
device itself and to the externally connected temperature sensor.
■ The device can be mounted directly on the wall or flush-mounted within a
pattress box.
Manual for PCD7.L6xx room operator units │ D ocument 26-859 ENG07 │ 2 015-06-04
Avoid direct exposure to sunlight or
light from powerful lamps.
Do not install next to heat sources such
as heaters, refrigerators, lamps etc.
Do not install next to windows and doors
because of draughts.
Do not located the control device/
compact room controller in the path
of draughts from climate control or
ventilation systems.
Assembly instructions
1
1-1
Advertisement
Table of Contents
