Light Group Sensor On, Off Via Network Command; Shade: 2 Groups Shades Up/Down - SBC PCD7.L630 Instruction Manual

Saia-Burgess Controls AG
3.2.3 Light:
Shade:
Base PCD7.L600
controller:
PCD7.L60x SBC S-Bus
In combination with S-Bus controllers, the light outputs are split into up to 4 light
groups using the Config F-Box, with the first two groups available for direct control via
this module. Groups 3 and 4 can be controlled via the room control unit and S-Bus.
PCD7.L611 LON
When the extension units are used with a LON controller, the light and shade outputs
must be assigned to the groups by "LON bindings". Without binding, a predefined
assignment of the outputs to groups is only effective for initial commissioning.
DIP switch
8
OFF
I1 Light group 1
I2 Light group 2
I5 Shade group 1 up
Manual for PCD7.L6xx room operator units │ D ocument 26-859 ENG07 │ 2 015-06-04
1 light group sensor on, off via network command
2 groups shades up/down
PCD7.L601
 
7 6
OFF OFF
PCD7.L602 PCD7.L603
 
5 4
OFF OFF OFF
I6 Shade group 1 down
I7 Shade group 2 up
I8 Shade group 2 down
Digital room controller units
PCD7.L610 PCD7.L611
-

3 2 1
ON ON
3
3-27