SBC PCD7.L630 Instruction Manual page 20

Saia-Burgess Controls AG
Function
Presence Sensor
Fan control
HeaVAC functions
The desired function is activated by pressing and holding the oval SET key (for
approx. 2 seconds). The active function is shown in the display by the flashing icon.
The setting can be changed with the up/down arrow keys. A short keystroke applies
the current setting.
Note
All analogue inputs on the room controller can be read by the S-Bus via a Room
FBox or via registers independently of the application.
The use of a digital room control unit must be indicated in the configuration.
See description of Config FBox or registers.
Manual for PCD7.L6xx room operator units │ D ocument 26-859 ENG07 │ 2 015-06-04
Description
The presence sensor can be used to change the operat-
ing mode manually to Comfort or Standby/unused. The
operating mode is shown in the display. The person icon
outside the little house indicates non-use; if this icon is
flashing, the controller is in Standby mode. In Comfort
mode, the person icon moves into the house.
The HeaVAC menu can be used to set the fan speed
manually. The room controller can only switch to the
desired step if this is allowed by the fan operating window.
See description of Config FBox or registers (reg. 63, 64)
Digital room controller units
3
3-9