Light; Groups Via Switch; Shade: 2 Groups Via Changeover Contacts Up/Down - SBC PCD7.L630 Instruction Manual

Saia-Burgess Controls AG

3.2.4 Light:

Shade:
Base PCD7.L600
controller:
DIP switch
8
OFF
I1 Light group 1
I2 Light group 2
I5 Shade group 1 up
Switching commands are sent once only as status changes at the time of the action
and are not constantly repeated. This enables e.g. a network command to control the
light independently of the current switch setting. Where communication has been set
to "after change" in the associated Room F-Box for the Saia PCD
command determines the current status. If, on the other hand, communication to the
Room F-Box is set to "permanent", a different switching command applies for just a
short time until the next communication cycle.
For a combination of light control via contacts and network, it is advisable to use
electronic sensors instead of switches. See application "2 light groups with key
commands 'on' and 'off'"
Manual for PCD7.L6xx room operator units │ D ocument 26-859 ENG07 │ 2 015-06-04
2 groups via switch
2 groups via changeover contacts up/down
PCD7.L601
 
7 6
OFF OFF
PCD7.L602 PCD7.L603
 
5 4
OFF OFF
I6 Shade group 1 down
I7 Shade group 2 up
I8 Shade group 2 down
Digital room controller units
PCD7.L610 PCD7.L611
-
3 2
ON OFF OFF
, the next switching
®

3
1
3-28