Light; Light Groups With Sensor Commands 'On' And 'Off; Shade: 2 Groups Up/Down Via Electronic Sensor - SBC PCD7.L630 Instruction Manual

Saia-Burgess Controls AG

3.2.1 Light:

Shade:
Base PCD7.L600
controller:
Sensor commands are sent once only as status changes at the time of the action and
are not constantly repeated. This enables e.g. a network command to control the light
independently of the current switch setting. Where communication has been set to
"after change" in the associated Room F-Box for the Saia PCD
command determines the current status. If, on the other hand, communication to the
Room F-Box is set to "permanent", a different switching command applies for just a
short time until the next communication cycle.
DIP switch
8
OFF
I1 Light group 1
I2 Light group 2
I5 Shade group 1 up
Manual for PCD7.L6xx room operator units │ D ocument 26-859 ENG07 │ 2 015-06-04
2 light groups with sensor commands 'on' and 'off'
2 groups up/down via electronic sensor
PCD7.L601
 
7 6
OFF OFF
PCD7.L602 PCD7.L603
 
5 4
OFF OFF OFF
I6 Shade group 1 down
I7 Shade group 2 up
I8 Shade group 2 down
Digital room controller units
PCD7.L610 PCD7.L611
-

, the next switching
®
3 2 1
OFF ON
3
3-25