SBC PCD7.L630 Instruction Manual page 33

Saia-Burgess Controls AG
Function
Number of light groups
Number of blind groups
Error codes
In the error case will be displayed a code with the letter "E" followed by a number.
Please contact your service organisation.
PCD7.L662 SV2.8
E1: Internal temperature sensor defect.
Manual for PCD7.L6xx room operator units │ D ocument 26-859 ENG07 │ 2 015-06-04
Description
The lighting is controlled by group commands. The as-
signment of individual lights to groups is part of the room
controller configuration. This may differ according to the
communications interface, and is described in the relevant
section of this Manual.
The room control unit has no knowledge of the room con-
troller configuration. It is therefore necessary to param-
eterise the number of supported light groups in the room
control unit separately.
Press and keys together for at least 5 seconds.
On the display, the light symbol flashes and the number of
light groups currently configured is shown. The
keys can be used to select the value 2, 4 or 8.
Factory setting: 2
Light and shade are controlled by group commands. The
assignment of individual blinds to groups is part of the
room controller configuration. This may differ according
to the communications interface, and is described in the
relevant section of this Manual.
The room control unit has no knowledge of the room con-
troller configuration. It is therefore necessary to param-
eterise the number of supported blind groups in the room
control unit separately.
Press and keys together for at least 5 seconds.
On the display, the blind symbol flashes and the number of
blind groups currently configured is shown. The
keys can be used to select the value 2, 4 or 8.
Factory setting: 2
Digital room controller units
and
and
3
3-22