Table of Contents
Advertisement
Saia-Burgess Controls AG
Commissioning / configuration
The functions are predefined within the module and are selected via the DIP switch.
New settings only take effect after a restart.
System properties - general
Control and sensor commands are sent once only as status changes at the time of
the action and are not constantly repeated. This enables e.g. a network command to
control the light independently of the current switch setting.
For a combination of light control via contacts and network, it is advisable to use
electronic sensors instead of switches.
SBC S-Bus
Where communication has been set to "after change" in the associated Room F-Box
for the Saia PCD
the other hand, communication to the Room F-Box is set to "permanent", a switching
command applies for just a short time until the next communication cycle.
Manual for PCD7.L6xx room operator units │ D ocument 26-859 ENG07 │ 2 015-06-04
Controller
PCD7.L60x
PCD7.L61x
, the next switching command determines the current status. If, on
®
Extension Modules/
Room control units
PCD7.L62x
PCD7.L64x
Configuration
set up
8 potential free contacts
Digital room controller units
3
3-24
Advertisement
Table of Contents
