Removing The Motor Control Unit - Whirlpool WFW94HEX Technical Education

REMOVING THE MOTOR CONTROL UNIT

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug washer or disconnect power.
2. Turn off the water supply to the washer.
3. Pull the washer away from the wall.
4. Remove the Top ("REMOVING THE DISPENSER
DRAWER, TOP AND CONSOLE ASSEMBLY") and
the hex-head screws (12) (arrows) from the
rear panel.
Remove Screws at these locations
to detach lower support bracket
5. Remove 2 screws that secure the lower brace
to have clear access to the motor control unit.
Cover
Slots
6. Release the slots from the tabs and open the
connector cover and remove 3 connectors.
7. The motor control unit is secured to the
washer bottom by means of 4 tabs and
slots. Push up to release the tab at the cor-
ner and push the unit toward the rear of the
washer to release and remove it.
Release Tab
4-16
Motor Control Unit
Connectors
Tabs
Mounting Tabs
Slots