Whirlpool WFW94HEX Technical Education page 11

LOC ATION REQUIREMENTS
Proper installa on is your responsibility.
You will need:
A water heater set to 120° F (49° C).
�
A grounded electrical outlet located within 6
�
power cord on back of washer.
Hot and cold water faucets located within 4
�
20-100 psi (137.9-689.6 kPa).
�
washer. Installing on carpet or surfaces with foam backing is
not recommended.
� Floor must support washer's total weight (with water and load)
of 315 lbs (143 kgs).
IMPORTANT: Do not install, store or operate washer where
it will be exposed to weather or in temperatures below 32° F
(0° C). Water remaining in washer a er use may cause damage
in low temperatures. See "Washer Care" in Washer Use and Care
Guide for winterizing informa on.
All dimensions show recommended spacing allowed, except for
closet door ven la on openings which are the minimum required.
For each arrangement, consider allowing more space for ease of
installa on and servicing, and spacing for companion appliances
Space must be large enough to allow door to fully open.
Add spacing of 1" (25 mm) on all sides of washer to reduce
noise transfer. If a closet door or louvered door is installed, top
and bo om air openings in door are required.
Recessed area or closet installa on
(stacked washer and dryer):
5"
(127 mm)
1"
(25 mm)
Custom under counter installa on:
1"
(25 mm)
LOCATION REQUIREMENTS
(1.8 m) of
(1.2 m) of hot
6"
(152 mm)
3"
(76 mm)
48 in .
(310 cm
/
77 "
1
2
(1969 mm)
24 in .
(155 cm
3"
(76 mm)
1"
(25 mm)
39" min.
(990 mm)
1"
(25 mm)
(1295 mm)
Recessed area or closet installa on (washer only):
2
4"
)
2
(102 mm)
2
)
2
Custom cabinet installa on:
(102 mm)
2-2
27"
51" (686 mm)
(800 mm)
3"
(76 mm)
34" min.
(864 mm )
3"
(76 mm)
1"
(25 mm)
1"
(25 mm)
7"
(178 mm)
14"
(356 mm)
4"
1"
(25 mm)
38"
(965 mm)
31 / "
1
2
48 in.
2
(310 cm )
2
24 in.
2
(155 cm )
2
1"
(25 mm )