Removing The Central Control Unit - Whirlpool WFW94HEX Technical Education

REMOVING THE CENTRAL CONTROL UNIT

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug washer or disconnect power.
2. Turn off the water supply to the washer.
3. Remove the top cover from the washer,
see "REMOVING THE DISPENSER DRAWER, TOP
AND CONSOLE ASSEMBLY" for procedure.
4. Pull the wire connectors off the edges of
the central control unit circuit board
(see figure 1). When removing an edge
connector, first loosen the locking tab on
the connector with a small screwdriver
blade to release it.
5. Slide the hooked ends of the two wire
clamps off the locking tabs, and remove
the wires from the clamps.
Central Control Unit
4-4
Central Control Unit Connectors (21)
Locking
Tab
6. Lift up on the locking tab, and push the
central control unit (CCU) toward the rear
of the washer and up as far as it will go, and
remove the CCU tabs from the keyhole slots
in the chassis.
Keyhole Slots
Back Side of Central Control Unit
Connector
Cover
Figure 1
Up
Push
CCU Tabs