Complete Installation - Whirlpool WFW94HEX Technical Education

INSTALLATION INSTRUCTIONS (continued)
17.
Adjust leveling feet
Jam nut
If If washer is not level, use a 9/16" or 14 mm open-end or If w f asher is not level use a 9/16" or 14 mm open-end or h i t l l 9/16"
adjustable wrench to turn jam nuts clockwise on feet until they
are about 1/2" (13 mm) from the washer cabinet. Then turn the
leveling foot clockwise to lower the washer or counterclockwise
to raise the washer. Recheck levelness of washer and that all
HELPFUL TIP: You may want to prop up front of washer
about 4" (102 mm) with a wood block or similar object that
will support weight of washer.
18.
Tighten leveling feet
Jam nut
to turn jam nuts counterclockwise on leveling feet tightly
against washer cabinet.
HELPFUL TIP: You may want to prop washer with
wooden block.
14 d
20.
Plug into a grounded 3 prong outlet

COMPLETE INSTALLATION

COMPLE TE IN S TA LL A TION
CHECK LIST
CHECK LIS T
Check electrical requirements. Be sure you have correct
�
electrical supply and recommended grounding method.
Check that all parts are now installed. If there is an extra
�
part, go back through steps to see what was skipped.
Check that you have all of your tools.
�
Check that transport materials were completely
�
removed from back of washer.
Check that both hot and cold hoses are attached and water
�
faucets are on.
Check for leaks around faucets, valves, and inlet hoses.
�
�
remaining on washer.
Check that washer is plugged into a grounded
�
3 prong outlet.
Dispose of/recycle all packaging materials.
�
Read "Using Your Washer" in your Washer Use and Care
�
Guide.
To test and clean your washer, press power and choose the
�
QUICK WASH cycle and run it without clothes. Use only HE
detergent. Use 1/2 the manufacturer's recommended amount
for a medium-size load.
2-8