Epson Stylus Photo RX700 Service Manual page 108

EPSON Stylus Photo RX900
Before installing the Printer Mechanism, check the following
conditions on the Lower Case Assy for properness:
•
Routing of the harness between the Power Supply Board ~
Main Board
•
Insulation of the Harness Clamp
Make sure that the Waste Ink Tubes (x2) are connected to the
Tube Holder properly.
A D J U S T M E N T
Adjustments are required. Once the Printer Mechanism has been
R E Q U I R E D
removed or replaced with a new one, refer to the following section
and perform the necessary adjustments.
5.1.1 Adjustment Items (p.134)
TPU Harness
Relay Connector
Harness Clamp (temporally fixed)
Figure 4-40. Checking the Lower Case Assy
Disassembly and Assembly
(See p.107)
Routing of the Power
Supply Board harness
Disassembly and Assembly of Major Parts of Printer
Pass through here
Figure 4-41. Installing the Printer Mechanism (right frame area)
After routing the Relay Harness and TPU
Harness, install the Harness Clamp.
Figure 4-42. Routing and Fastening of Harness
C H E C K
Route the TPU Harness and Relay Harness under the Harness
P O I N T
Clamp.
Revision A
Route the lead wires in an innermost position so
that the printer frame will not be interfered with.
108