Heatscope MHS-600 Original Installation And Operating Instructions page 9

4.2.2 HEATSCOPE™ MHS-WHSL
· Diagram (6) shows the HEATSCOPE™ together with the adjustable wall bracket MHS-WHSL.
· Fit the pre-assembled adjustable wall bracket MHS-WHSL (1) on/to the intended installation surface.
(Please note the minimum clearance for installation surfaces in Section 6.)
· The scope of delivery includes two different adjustable mounting brackets MHS-WHSL with different
orientation for mounting on the left or right side. The securing clips of the mounting bracket must
always be oppositely aligned to each other and face outward (4).
· Remove the two screws (2) slightly (do not loosen the nuts!) and adjust the mounting bracket to exactly
the right angle. Then tighten the screws (2) again.
· Repeat these steps (1 and 2) with the second wall bracket MHS-WHSL. Make sure that both mounting
brackets (1) are mounted exactly in series one after the other and that the securing clips are facing
outward.
· Now slide the HEATSCOPE™ (3) onto the mounting brackets until the clip (4) clicks audibly into place on
both sides above the raised side plate (5) and the HEATSCOPE™ is secured from slipping out.
2
1
5
Scope of delivery
2 x wall brackets
2 x rotary elements
2 x mounting
brackets
(already fully pre-
assembled)
3
Figure: (1) Mounting bracket MHS-MH; (2) Adjustable wall bracket MHS-WHSL;
(3) HEATSCOPE™ radiant heater; (4) Securing clip on mounting bracket; (5) Raised
side plate; (6) HEATSCOPE™ incl. adjustable wall bracket MHS-WHSL
Drilling dimensions
4
6