Heatscope MHS-600 Original Installation And Operating Instructions page 7

4.1 HEATSCOPE™ MHS-MH
· Diagram (5) shows the HEATSCOPE™ together with the pre-assembled mounting bracket MHS-MH.
· Fit the mounting bracket MHS-MH (1) on/to the intended installation surface. (Please note the mini-
mum clearance for installation surfaces in Section 6.)
· Repeat this step (1) with the second mounting bracket. Make sure that both mounting brackets are
mounted exactly in series one after the other and that the securing clips (3) are oppositely aligned to
each other and are facing outward.
· Now slide the HEATSCOPE™ (2) onto the mounting brackets until the clip (3) clicks audibly into place on
both sides above the raised side plate (4) and the HEATSCOPE™ is secured from slipping out.
Scope of delivery
2 x wall brackets
4 x screws M6
(including washers)
4 x nuts M6
1
2
3
4
Figure: (1) Mounting bracket MHS-MH; (2) HEATSCOPE™ radiant heater; (3)
Securing clip on mounting bracket; (4) Raised side plate; (5) HEATSCOPE™ incl.
mounting bracket MHS-MH
Mounting bracket drilling dimensions
5