Table of Contents
Advertisement
9.5 Dial plan
The Dial Plan is used to collect digits and setup outbound calls for use with VOIP calling.
Direct call is possible using this Dialplan table. Direct call means that specific destination
routed to the called party directly over IP network without intermediary Proxy Server.
1) Direct call uses only IP interface port number 0 which means WAN interface
2) Number is the destination of Direct Call which means a called party.
3) Truncation means that how many digits are stripped before digits send out.
4) Prefix number is added just before digits send out.
5) Peer IP Address is the destination of the direct call.
For instance, there is a direct call list like above figure. Then, the dialed 123 will head to the
destination 192.168.2.52 directly with 4563 at the "To" header.
To delete any list on the Dialplan table, check out the Remove then click on the Set Values.
NOTE
„*‟ : The star key is on a traditional telephone dialpad.
„#‟ : The pound key is on a traditional telephone dialpad. And it indicates
the end of digit string when it is followed digit strings.
Instruction
*6[0189] & *7[0-35] indicates the local service code. ". Therefore, service
code for centralized hosted supplementary service has to use different
one or has to add the code format specifically at the dialplan. For
instance,
*72#~ when service code format is code+#+DN.
DV-302 OPERATION MANUAL
43
Advertisement
Table of Contents
