Table of Contents
Advertisement
DV-302 OPERATION MANUAL
2) Log in to the DV-302 Web Interface.
3) Enter the IP address of the TFTP server and enter the name of firmware (as shown in
the above screen), then click on the "Start Download" button.
4)
When downloading is complete, the status will be displayed as "Completed."
5) The system must be rebooted after the Firmware is upgraded to apply the new
image.
DV-302 supports FTP server and Client function for software upgrade. The most convenient
method is to invoke FTP Daemon to upgrade new software.
To upgrade using the Manual FTP method:
1)
The computer should be set up to make a Telnet connection to the Gateway from the
LAN-side or WAN-side in order to enable the FTP Daemon (FTP Server), as shown.
2) Make sure that the DV-302 and PC are connected by performing a ping test.
3) The default IP address for the gateway PC port is 192.168.0.1; the PC may obtain the
IP address from the DV-302 among 192.168.0.10-42 when the PC network
configuration mode is set for DHCP.
NOTE
The default FTPD is disabled.
Instruction
If the PC LAN mode is static, set any IP address between 192.168.0.2 -
192.168.0.254, subnet 255.255.255.0, gateway 192.168.0.1.
46
Advertisement
Table of Contents
