Appendix A. Ivr Configuration - Davolink DV-302 Operation Manual

DV-302 OPERATION MANUAL

Appendix A. IVR Configuration

After connecting the power cable to the DV-302, it generally takes about 30 seconds for System
Initialization. A dial tone will be present when picking up the connected handset. Once the
System is properly set up, internet line and internet telephony can be registered.
This feature is useful along with the Auto-Provisioning feature. In this case, when the System
device is connected to the internet, the VoIP service automatically will be enabled. Therefore
the device does not need to be manually configured.
Interactive Voice Response (IVR)
There is an interactive voice menu to verify the status of the UA.
Interactive Voice Response (IVR) menu and how to start IVR:
1) Begin by dialing, ***0 on the telephone key pad; the initial voice configuration menu
should be heard.
2) Push ***0 to start IVR mode.
3) Enter the password (ex., 1234#).
4) Using the telephone keypad, enter the voice menu code (refer to Table) for the
parameter that you wish to configure or the command that you want to execute, then
press the # .key.
OPTION
WAN Address OP mode
WAN Address Setting
WAN Netmask Setting
WAN Gateway Address
WAN DNS Address
PPPoE ID
PPPoE P/W
PPPoE Service Name
LAN mode
MAC IP Address
TABLE A-1. INTERNET CONNECTION CODES
SERVICE CODE
REVIEW WRITE
001 101
002 102
003 103
004 104
005 105
006 106
007 107
008 108
009 109
010 110
DESCRIPTION
1=static, 2=DHCP, 3=PPPoE
Enter the IP address
Enter the subnet mask
Enter the gateway address
Enter the DNS server IP address
Enter PPPoE ID
Enter PPPoE P/W
Enter PPPoE Service company name
Enter IP allocation mode
1 for NAT mode, 2 for One IP mode
Enter the MAC IP address
50
This section describes the