Operating The Generator - Hyundai DHY6000SELR2 User Manual

4. OPERATING THE GENERATOR

4.1. Starting.
4.1.1. Turn the main AC switch to the 'OFF' position.
4.1.2. Make sure that the machine has sufficient fuel.
4.1.3. Set the engine speed lever is set to 'RUN'. 4.1.4.
Turn the starting key clockwise to the 'START'
position.
4.1.5. Remove your hand from the key as soon as the
engine starts.
4.1.6. If the engine does not start after 10 seconds, wait
15 seconds before trying again. Excessive start
attempts will cause the battery to discharge.
4.1.7. If it does not start after 3 attempts, or runs
intermittently with excessive smoke check that the
fuel system is fully primed.
4.1.7.1. Priming - before starting to prime make sure that
there is sufficient fuel in tank and that you can
contain any fuel spilt.
4.1.7.1.1.
4.1.7.1.2.
4.1.7.1.3.
 Do not loosen or readjust either the engine speed limiting bolt or the
fuel injection limiting bolt as this will cause the performance of the
generator to be affected.
Begin by releasing the fuel pipe clip on the diesel fuel line connected to
the injector pump. Remove the pipe and make sure you pinch the fuel line,
then slowly release until all air is released and fuel appears.
When fuel appears replace the fuel pipe onto the injector pump
and replace clip. Clear up any fuel spills before restarting.
The above may be necessary when new, or if the machine runs out of
fuel.
Page 14