Load - Hyundai DHY6000SELR2 User Manual

4.1.8. Always leave the key in the 'ON' position whilst the engine is running.
4.1.9. Run machine for two minutes before applying load
4.1.10. Insert the plug into the socket you are about to use.
4.1.11. Turn the main AC switch to the 'ON' position and turn the electrical appliance 'ON'.
4.2. Checks whilst generator is running.
4.2.1. After each use make sure that there are no abnormal sounds or vibration.
4.2.2. Check that the engine is running smoothly.
4.2.3. Check that there is no excessive smoke form the exhaust after 10 minutes of
running, and the engine has reached working temperature
4.2.4. Check that there are no oil or fuel leaks.

5. LOAD

5.1. 230 Volt AC use.
5.1.1. With engine running switch ON the main breaker switch, with
the engine running check the Voltmeter is reading read 230v ±
5% (@50Hz).
5.1.2. Connect the equipment to the generator in the correct order.
5.1.3. Connecting the loads with the largest motor first, then the
smaller items.
5.1.4. If the generator is overloaded the main breaker will trip.
 If the engine has been running, the muffler will become very hot. Be
careful not to touch the muffler until it has had time to fully cool
down.
 Never fill the fuel tank whilst the engine is still running.
 If you notice any of the above, stop the engine and locate the
fault.
 Please contact Genpower for assistance if required.
 Always start appliances one-by-one.
Page 15