Brother DCP-J562DW Online User's Manual page 455

Error Message
Ink Absorber Pad
NearFull
Ink Low
Jam A Inside/Front
Repeat Jam A Inside/
Front
Jam B Front
Repeat Jam B Front
Jam C Rear
Low Temperature
Cause
frequent cleanings because non-Brother
ink could cause poor print quality which is
resolved by cleaning. The more cleaning
the machine requires, the faster these
boxes will fill up.
Repairs resulting from the use of non-
Brother supplies may not be covered
under the stated product warranty.
The ink absorber box or flushing box is
nearly full.
One or more of the ink cartridges are near
the end of their lives. If one of the colour
ink cartridges is near the end of its life and
someone is sending you a colour fax, your
machine's "handshake" will ask that the
fax be sent as monochrome. If the
sending machine has the ability to convert
it, the colour fax will be printed at your
machine as a monochrome fax.
The paper is jammed in the machine.
More than one sheet of paper was placed
in the manual feed slot.
-OR-
Another sheet of paper was placed in the
manual feed slot before the Touchscreen
displayed Where to Place the
Paper.
The paper is jammed in the machine.
The paper is jammed in the machine.
Paper dust has accumulated on the
surface of the paper pick-up rollers.
The room temperature is too low.
Action
The ink absorber box or flushing box must
be replaced soon. Contact Brother
customer service or your local Brother
dealer.
Order a new ink cartridge. You can
continue printing until the Touchscreen
displays Cannot Print.
See Related Information: Replace the Ink
Cartridges.
• You can still scan even if the ink is
low or needs to be replaced.
Remove the jammed paper.
See Related Information: Paper is
Jammed Inside and in the Front of the
Machine (Jam A Inside/Front).
Make sure the paper length guide is set to
the correct paper size.
Do not put more than one sheet of paper
in the manual feed slot at any one time.
Wait until the Touchscreen displays
Where to Place the Paper before
you feed the next sheet of paper in the
manual feed slot.
Remove the jammed paper.
See Related Information: Paper is
Jammed Inside and in the Front of the
Machine (Jam A Inside/Front).
Remove the jammed paper.
See Related Information: Paper is
Jammed in the Front of the Machine (Jam
B Front).
Make sure the paper length guide is set to
the correct paper size.
Remove the jammed paper.
See Related Information: Paper is
Jammed in the Back of the Machine (Jam
C Rear).
Make sure the paper length guide is set to
the correct paper size.
Clean the paper pick-up rollers.
See Related Information: Clean the Paper
Pick-up Rollers.
After warming the room, allow the
machine to warm up to room temperature.
Try again when the machine has warmed
up.
449