Brother DCP-J562DW Online User's Manual page 390

3. When [Switch Network interface to wireless?] or [Enable WLAN?] appears, press [Yes].
This will start the wireless setup wizard. To cancel, press [No].
4. The machine will search for your network and display a list of available SSIDs. Press a or b to display the
[<New SSID>] option, and then press it.
5. Press [OK].
6. Enter the SSID name, and then press [OK].
For more information about how to enter text, see the Appendix.
7. Press [Infrastructure].
8. Select the Authentication Method, and then press it.
9. Do one of the following:
• If you selected the [Open System] option, press either [None] or [WEP].
If you selected the [WEP] option for Encryption type, enter the WEP key, and then press [OK].
• If you selected the [Shared Key] option, enter the WEP key, and then press [OK].
• If you selected the [WPA/WPA2-PSK] option, press either [TKIP+AES] or [AES].
Enter the WPA key, and then press [OK].
• For more information about how to enter text, see the Appendix.
• Your Brother machine supports the use of the first WEP key only.
10. To apply the settings, press [Yes]. To cancel, press [No].
11. The machine will attempt to connect to the wireless device you have selected.
If your wireless device is connected successfully, the LCD displays [Connected].
®
For Windows :
You have completed the wireless network setup. Use the Brother Installation CD-ROM to install drivers and
software necessary for operating your device.
For Macintosh:
You have completed the wireless network setup. Go to your model's Downloads page on the Brother Solutions
Center at http://support.brother.com
Related Information
• Additional Methods of Configuring Your Brother Machine for a Wireless Network
• I Cannot Complete the Wireless Network Setup Configuration
to install drivers and software necessary for operating your device.
384