DCP-J562DW/MFC-J680DW/MFC-J880DW
1. Press
[Settings] > [All Settings] > [Network] > [WLAN] > [WPS/AOSS].
2. When [Switch Network interface to wireless?] or [Enable WLAN?] appears, press [Yes].
This will start the wireless setup wizard. To cancel, press [No].
3. When the Touchscreen instructs you to start WPS or AOSS
wireless access point/router. Then press [OK] on your machine. Your machine will automatically detect
which mode (WPS or AOSS
network.
If your wireless device is connected successfully, the LCD displays [Connected].
®
For Windows
:
You have completed the wireless network setup. Use the Brother Installation CD-ROM to install drivers and
software necessary for operating your device.
For Macintosh:
You have completed the wireless network setup. Go to your model's Downloads page on the Brother Solutions
Center at
http://support.brother.com
Related Information
•
Additional Methods of Configuring Your Brother Machine for a Wireless Network
™
) your wireless access point/router uses and try to connect to your wireless
to install drivers and software necessary for operating your device.
™
, press the WPS or AOSS
™
button on your
376