Scan Photos And Graphics - Brother DCP-J562DW Online User's Manual

Hide thumbs Also See for DCP-J562DW:

Table of Contents

Scan Using the Scan Button on Your Brother Machine

Scan Photos and Graphics

Send scanned photos or graphics directly to your computer.

Use the Scan button on the machine to make temporary changes to the scan settings. To make permanent

changes, use Brother's ControlCenter software.

>> MFC-J480DW

>> DCP-J562DW/MFC-J680DW/MFC-J880DW

1. Load your document.

3. Press a or b to select the [Scan to Image] option, and then press OK.

4. If the machine is connected over the network, press a or b to select the computer where you want to send

data, and then press OK.

If the LCD prompts you to enter a PIN, use the control panel to enter the four-digit PIN for the computer,

and then press OK.

5. Do one of the following:

To change the settings, go to the next step.

To use the default settings, press Mono Start or Colour Start.

[Scan Type] depends on the default settings. Pressing Mono Start or Colour Start does not allow you to

change the settings.

6. Press a or b to select the [Scan Settings] option, and then press OK.

To use the [Scan Settings] option, a computer with the ControlCenter software installed must be

connected to the machine.

7. Press a or b to select the [Set at Device] option, and then press OK.

8. Select the scan settings you want to change, and then press OK.

Select the scan type for your document.

Select the scan resolution for your document.

Select the file format for your document.

> Scan Photos and Graphics

Mfc-j680dw Mfc-j480dw Mfc-j880dw