Installation Guide
The two pin DC power connector (phase-in) is shown below. All other connections, ports, and the LED status panel
are the same.
The horizontal (HP) and vertical (VP) connectors for the antenna cables are located on the top of the AP 7181.
All radome antenna panel cables are labeled as HP or VP. Attach each cable to the corresponding connector when
performing a remote panel installation or any other procedure which requires attaching antenna cables to the
connectors.
NOTE
The connectors on the AP 7181 are Ingress Protection 67 (IP67) rated. No additional
weatherproofing precautions are required.
17