Motorola AP 7181 Installation Manual page 37

Installation Guide
11. The set screw can now be inserted to increase stability. Using a 21mm socket with torque wrench, tighten
the set screw from 214.2 - 250.0 inch pounds (lbf-in).
NOTE
12. If the AP 7181 you are mounting is a Mesh Point Root node or a Mesh Point node with an external device
(e.g. surveillance camera), perform the required Ethernet cabling.
The Ethernet cable gland is optimized for cables of diameter .39 - .55 inches. Smaller diameter cables can
achieve a watertight seal if the cable gland is properly tightened during installation. It is recommended
that an outdoor UV rated, shielded cable is used in AP 7181 deployments. Some examples are:
• Superior Essex 04-001-55
• Best-Tronics BT-0562
In most cases, Ethernet cable is custom cut to length. After preparing the Ethernet cable and attaching
shielded RJ-45 end connectors feed the cable through the cable gland cap and rubber insert as shown
below.
Only one set screw is included with each AP 7181 kit. If a second set screw is required,
purchase an M14x2.0, 20mm stainless steel hexagonal screw.
37