Figure 25 Configuration Table; Table 21 Configuration Table Fields - Nortel Optivity Switch Using Manual

72 Chapter 4 Using VLAN Manager

Figure 25 Configuration table

Table 21

Table 21 Configuration table fields

Field
Device
Priority
BridgeMaxAge
BridgeHelloTime
BridgeForwardDelay
EnableStp
StpTrapEnable
208963-B
describes the fields in the Configuration table.
Description
IP address, system name, or host name of the device.
The Spanning Tree Protocol (STP) bridge priority, in decimal.
The range is 0 (highest priority) to 65535 (lowest priority). The
default is 32768.
The value in hundredths of a second that all bridges use for
MaxAge when this bridge is acting as the root.
Note: The 802.1D-1990 standard specifies that the range for
this parameter is related to the value of dot1dStp\Time.
The default is 2000 (20 seconds).
The value in hundredths of a second that all bridges use for
Hello Time when this bridge is acting as the root. The granularity
of this timer is specified by the IEEE 802.1D-1990 standard to
be in increments of 1/100 of a second. The default is 200
seconds.
The value in hundredths of a second that all bridges use for
Forward Delay when this bridge is acting as the root. The default
is 1500 (15 seconds).
Enables or disables the spanning tree algorithm for the spanning
tree group.
Enables or disables SNMP traps to be sent to trace receiver
every time an STP topology change occurs.