Table of Contents
Advertisement
Copyright © 2006 Nortel Networks
Procedure 6 Connecting through the server to the MRV LX
terminal server
At the management pc,
1
Procedure 7 Changing the password defaults
At the management pc,
1
2
3
NN10364-301 MCS 5100 3.5 Standard 6.0 December 2006
MRV Communications recommends that you change the default
password for the user's MRV LX terminal server before you put
the unit on a network. For more information, refer to
password defaults on page
Use the following procedure to access the command line
interface port from a dumb terminal attached to an LX Series
serial port, which is set for access local or dynamic:
a Hit the return key several times to autobaud (if autobaud is
enabled) the port and get the login prompt.
b Enter your login name. The default is InReach.
c Enter your password. The default is access.
The default password for the MRV LX terminal server user is
access. If an unauthorized user knew this username/password
combination, that user could log on to your unit. For this reason,
you should change the user's password to something other than
access.
The default Superuser password is system. To reduce the risk of
an unauthorized user gaining access to the Superuser
Command Mode, MRV recommends that you change this
password to something other than system.
To change the user-level password, access the Configuration
Command Mode.
Access the Subscriber Command Mode for the subscriber by
entering the subscriber command with InReach as the
command argument; for example: Config:0 >>subscriber
InReach
Enter the password command at the Subs_InReach >>
prompt.
40
ATTENTION
40.
Changing the
Advertisement
Table of Contents
