show ports stats pos felineinterval
This command displays statistics
interval. You specify which interval, or span of intervals, to display for the
command. The command uses the syntax:
show ports stats pos felineinterval <intervalid>
Figure 38 show ports stats pos felineinterval command output
Passport-8610:5/show/ports/stats/pos# felineinterval 4
======================================================================
======================================================================
PORT
ERRORED SECONDS
NUM
COUNT (ES)
----------------------------------------------------------------------
10/5
0
10/6
0
INTERVAL ID = 4
Passport-8610:5/show/ports/stats/pos#
Table 39
pos felineinterval
POS Far End Line Interval Stats
SEVERELY ERRORED
COUNT (SES)
0
0
describes the information fields for output of the show ports
command
Chapter 6 Command line interface
(Figure
38) on the far end line over a 15-minute
CODE VIOLATION UNAVAILABLE
COUNT (CV-L) SECONDS(UAS)
0
0
Using the Passport 8683POS Module
107
[
<ports>
]
0
0
stats