92
Chapter 6 Command line interface
Configuration commands
This section describes the configuration commands available with the Passport
8683POS Module. There are two types of configuration commands:
•
Module commands
•
Port commands
config poscard commands
The
•
Reset the module
•
Enable trace messages
•
Display the image filename for the Passport 8683POS Module
The syntax is:
config poscard
where
chassis.
Table 30 describes the parameters and variables for the config poscard
command.
209564-A
Note: If you replace one card with another type of card, Nortel
Networks recommends that you go to the root level of the CLI directory
before you use any CLI commands.
command allows you to:
config poscard
<posslot number>
<posslot number>
is the slot number of the module in the Passport 8600